Chapter 7 WAN
NBG-418N v2 User’s Guide
88
Autoconfiguration
Type
Select SLAAC + Stateless DHCPv6 if you want the interface to automatically generate
a link-local address via stateless autoconfiguration.
Select Stateful(DHCPv6) when the devices connected to your LAN needs to have their
TCP/IP configuration set to DHCPv6 or obtain an IPv6 address automatically.
Router
Advertisement
Lifetime
If you select SLAAC + Stateless DHCPv6, type in the Router Advertisement
Lifetime which is the amount of time in minutes that a device may have an IPv6
address before it is required to renew the lease.
IPv6 Address
Range(Start)
If you select Stateful (DHCPv6), specify the range of IPv6 addresses from which the
DHCPv6 server assigns to the clients. Enter the smallest value of the last block of the
IPv6 addresses which are to be allocated.
IPv6 Address
Range(End)
If you select Stateful (DHCPv6), specify the range of IPv6 addresses from which the
DHCPv6 server assigns to the clients. Enter the largest value of the last block of the
IPv6 addresses which are to be allocated.
IPv6 Address
Lifetime
If you select Stateful (DHCPv6), specify how long (in minutes) the IPv6 addresses
remain valid.
Apply Click Apply to save your changes back to the NBG-418N v2.
Reset Click Reset to begin configuring this screen afresh.
Table 38 Network > WAN > IPv6 (continued)(SLAAC/DHCPv6)
LABEL DESCRIPTION
To Next Page
Loading...
