Chapter 7 Broadband
NR/FWA Indoor Series User’s Guide
106
7.4 Ethernet WAN
Use this screen to have a LAN port act as an Ethernet WAN port. When the switch goes to the right, the
LAN port acts as an Ethernet WAN port. Otherwise, the LAN port remains as a LAN port. Click Apply to
save your changes back to the Zyxel Device.
Click Network Setting > Broadband > Ethernet WAN to display the following screen.
Figure 54 Network Setting > Broadband > Ethernet WAN
7.5 Cellular WAN
Click Network Setting > Broadband > Cellular WAN to display the following screen. Use this screen to
enable data roaming and network monitoring when the Zyxel Device cannot ping a base station.
Note: Roaming charges may apply when Data Roaming is enabled.
Check Fail Limit Enter the number of times that your Zyxel Device will ping the IP addresses
configured in the Destination for Connection Check field without getting a response
before switching to a WAN backup connection (or a different WAN backup
connection).
Cancel Click Cancel to exit this screen without saving.
Apply Click Apply to save your changes.
Table 22 Network Setting > Broadband > WAN Backup (continued)
LABEL DESCRIPTION
To Next Page
Loading...
