Chapter 29 Remote Management
NR/FWA Indoor Series User’s Guide
295
Figure 180 Maintenance > Remote Management > Trust Domain > Add Trust Domain
The following table describes the fields in this screen.
29.4 MGMT Services for IP Passthrough
Configure which interfaces you can use to access the Zyxel Device when IP Passthrough is enabled for a
given service. You can also specify the service port numbers computers must use to connect to the
Zyxel Device. IP Passthrough allows Internet traffic to go to a LAN computer behind the Zyxel Device
without going through NAT. Make sure to enable IP Passthrough in Network Setting > Broadband >
Cellular IP Passthrough.
Click Maintenance > Remote Management > MGMT Services for IP Passthrough to open the following
screen.
Figure 181 Maintenance > Remote Management > MGMT Services for IP Passthrough
Table 125 Maintenance > Remote Management > Trust Domain > Add Trust Domain
LABEL DESCRIPTION
IP Address Enter a public IPv4/IPv6 IP address which is allowed to access the service on the
Zyxel Device from the WAN.
OK Click OK to save your changes back to the Zyxel Device.
Cancel Click Cancel to restore your previously saved settings.
To Next Page
Loading...
