Chapter 7 Broadband
NR/FWA Indoor Series User’s Guide
117
7.11 Cellular SMS
Use this screen to send and receive SMS messages using the SIM card installed in the Zyxel Device.
Click Network Setting > Broadband > Cellular SMS. The following screen displays.
Figure 66 Network Setting > Broadband > Cellular SMS
The following table describes the fields in this screen.
Passthrough
Mode
Select Dynamic to allow traffic to be forwarded to the first LAN computer on the local network of
the Zyxel Device. Select Fixed to allow traffic to be forwarded to a specific computer (for
example, Client A) by entering its MAC address.
Note: This field will show after enabling IP Passthrough in the previous field.
Passthrough
to fixed MAC
Enter the MAC address of a LAN computer on the local network of the Zyxel Device upon
selecting Fixed in the previous field.
Note: This field will show after selecting Fixed in the previous field.
Apply Click this to save your changes.
Cancel Click this to exit this screen without saving.
Table 30 Network Setting > Broadband > Cellular IP Passthrough (continued)
LABEL DESCRIPTION
Table 31 Network Setting > Broadband > Cellular SMS
LABEL DESCRIPTION
Add New Message Click this button to open the Send New Message screen and send an SMS message
from the Zyxel Device.
SMS Inbox
SMS Inbox Enable Click this to enable or disable the SMS Inbox.
When enabled, the Zyxel Device can receive and display SMS messages.
# This displays the index number of the received message.
From This displays the phone number that sent the message.
To Next Page
Loading...
