NR/FWA Indoor Series User’s Guide
47
CHAPTER 5
Web Interface Tutorials
5.1 Web Interface Overview
This chapter shows you how to use the Zyxel Device’s various features.
• Wired Network Setup
• WiFi Network Setup
• Cellular Network Setup
• USB Applications
• Network Security
• Internet Calls
• Device Maintenance
5.2 Wired Network Setup
This section shows you how to set up a wired connection.
Set the Zyxel Device to Routing mode or Bridge mode on this connection as follows:
• Use Routing mode if you want the Zyxel Device to use routing mode functions such as NAT, Firewall, or
DHCP Server. You will need to reconfigure your network if you have an existing router.
• Use Bridge mode to pass the ISP-assigned IP address(es) to your devices connected to the LAN port.
All traffic from the Internet passes through the Zyxel Device directly to devices connected to the LAN
port. Use this mode if you already have a router with complete routing functions in your network.
5.2.1 Setting Up an Ethernet Connection
If you connect to the Internet through an Ethernet connection, you need to connect a broadband
modem or router with Internet access to the WAN Ethernet port on the Zyxel Device. You need to
configure the Internet settings from the broadband modem or router on the Zyxel Device. First, make
sure you have Internet access through the broadband modem or router by connecting directly to it.
This example shows you how to configure an Ethernet WAN connection.
To Next Page
Loading...
