ZyXEL Communications NWA5123-NI - Chapter 11: MON Profile; 11.2 MON Profile

NWA / WAC Series User’s Guide
126
CHAPTER 11
MON Profile
11.1 Overview
This screen allows you to set up monitor mode configurations that allow your NWA/WAC to scan for
other wireless devices in the vicinity. Once detected, you can use the Wireless > MON Mode screen
(Section 7.3 on page 88) to classify them as either rogue or friendly.
Not all NWA/WACs support monitor mode and rogue APs detection.
11.1.1 What You Can Do in this Chapter
The MON Profile screen (Section 11.2 on page 126) creates preset monitor mode configurations that can
be used by the NWA/WAC.
11.2 MON Profile
This screen allows you to create monitor mode configurations that can be used by the APs. To access
this screen, log into the Web Configurator, and click Configuration > Object > MON Profile.
Figure 79 Configuration > Object > MON Profile
The following table describes the labels in this screen.
Table 59 Configuration > Object > MON Profile
LABEL DESCRIPTION
Add Click this to add a new monitor mode profile.
Edit Click this to edit the selected monitor mode profile.
Remove Click this to remove the selected monitor mode profile.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.