ZyXEL Communications NWA5123-NI - NWA1123-AC HD, NWA5123-AC HD and WAC6303 D-S

Chapter 1 Introduction
NWA / WAC Series User’s Guide
32
The following table describes the LEDs.
1.6.6 NWA1123-AC HD, NWA5123-AC HD and WAC6303D-S
The following are the LED descriptions for your NWA/WAC.
Table 12 WAC5302D-S LEDs
LED COLOR STATUS DESCRIPTION
PWR/SYS Red Slow Blinking (On for 1s,
Off for 1s)
The WAC is booting up.
Green On
Red Off The WAC is ready for use.
Green On
Red On There is system error and the WAC cannot boot up, or the
WAC suffered a system failure.
Green Off
Red Fast Blinking (on for
50ms, Off for 50ms)
The WAC is doing firmware upgrade.
Green Off
Red Slow Blinking (blink for 3
times, Off for 3s)
The Uplink port is disconnected.
Green Off
Red Slow Blinking (blink for 2
times, Off for 3s)
The wireless module of the WAC is disabled or failed.
Green Off
Management Green On The WAC AP is managed by a controller.
Slow Blinking (blink for 3
times, Off for 3s)
The WAC AP is searching (discovery) for a controller.
Off The WAC AP is in standalone mode.
UPLINK Amber/
Green
On Amber - The port is operating as a 10/100-Mbps
connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
Blinking The WAC is sending/receiving data through the port.
Off The port is not connected.
WLAN Green On The 2.4 GHz WLAN is active.
Off The 2.4 GHz WLAN is not active.
WLAN Green On The 5 GHz WLAN is active.
Off The 5 GHz WLAN is not active.
LAN Amber/
Green
On Amber - The port is operating as a 10/100-Mbps
connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
Blinking The LAN port is sending/receiving data through the port.
Off The LAN port is not connected.