Chapter 3 Setup Wizard
NWA / WAC Series User’s Guide
49
Click Prev to return to the previous screen. Click Next to proceed. Click Cancel to close the wizard
without saving.
Figure 21 Wizard: Uplink
3.2.4 Radio
Use this screen to configure the NWA/WAC’s radio transmitter(s).
• Channel Selection: Select Auto to have the NWA/WAC automatically choose a radio channel that
has least interference. Otherwise, select Manual and specify a channel the NWA/WAC will use in the
2.4GHz or 5GHz wireless LAN. The options vary depending on the frequency band and the country
you are in.
• Maximum Output Power: Enter the maximum output power of the NWA/WAC. If there is a high density
of APs in an area, decrease the output power of the NWA/WAC to reduce interference with other
APs.
Note: Reducing the output power also reduces the NWA/WAC’s effective broadcast radius.
Click Prev to return to the previous screen. Click Next to proceed. Click Cancel to close the wizard
without saving.
To Next Page
Loading...
