Chapter 1 Introduction
NWA / WAC Series User’s Guide
29
1.6.3 NWA5301-NJ
The LEDs automatically turn off when the NWA5301-NJ is ready. You can press the LED ON button for one
second to turn on the LEDs again. The LEDs will blink and turn off after two minutes.
Figure 7 NWA5301-NJ LEDs
The following are the LED descriptions for your NWA5301-NJ.
Locator White Blinking The Locator is activated and will show the actual location
of the NWA/WAC between several devices in the
network.
Off The Locator function is off.
Table 9 NWA1123-AC PRO and WAC6103D-I LEDs (continued)
LED COLOR STATUS DESCRIPTION
Table 10 NWA5301-NJ LEDs
LABEL COLOR STATUS DESCRIPTION
PWR/SYS Amber Slow Blinking (On for 1s,
Off for 1s)
The NWA is booting up.
Green On
Amber Off The NWA is ready for use.
Green On
Amber Slow Blinking (blink for 3
times, Off for 3s)
The NWA is discovering an AP controller
Green On
Amber On The NWA failed to boot up or is experiencing system
failure.
Green Off
Amber Fast Blinking (On for
50ms times, Off for
50ms)
The NWA is undergoing firmware upgrade.
Green Off
Amber Slow Blinking (blink for 3
times, Off for 3s)
The Uplink port is disconnected.
Green Off
Amber Slow Blinking (blink for 2
times, Off for 3s)
The wireless module of the WAC is disabled or failed.
Green Off
PoE Green On Power is supplied to the yellow PoE Ethernet port (LAN1).
Off There is no power supply.
To Next Page
Loading...
