ZyXEL Communications NWA5123-NI - Page 28

Chapter 1 Introduction
NWA / WAC Series User’s Guide
28
The following table describes the LEDs.
Table 9 NWA1123-AC PRO and WAC6103D-I LEDs
LED COLOR STATUS DESCRIPTION
PWR/SYS Red Slow Blinking (On for 1s,
Off for 1s)
The NWA/WAC is booting up.
Green On
Red Off The NWA/WAC is ready for use.
Green On
Red On There is system error and the NWA/WAC cannot boot up,
or the NWA/WAC suffered a system failure.
Green Off
Red Fast Blinking (on for
50ms, Off for 50ms)
The NWA/WAC is doing firmware upgrade.
Green Off
Red Slow Blinking (blink for 3
times, Off for 3s)
The Uplink port is disconnected.
Green Off
Red Slow Blinking (blink for 2
times, Off for 3s)
The wireless module of the NWA/WAC is disabled or
failed.
Green Off
Management Green On The NWA/WAC is managed by a controller.
Slow Blinking (blink for 3
times, Off for 3s)
The NWA/WAC is searching (discovery) for a controller.
Off The NWA/WAC is in standalone mode.
WLAN Green On The antenna switch is set to “Ceiling” for the radio.
The 2.4 GHz WLAN is active.
Amber On The antenna switch is set to “Wall” for the radio.
The 2.4 GHz WLAN is active.
Off The 2.4 GHz WLAN is not active.
WLAN Green On The antenna switch is set to “Ceiling” for the radio.
The 5 GHz WLAN is active.
Amber On The antenna switch is set to “Wall” for the radio.
The 5 GHz WLAN is active.
Off The 5 GHz WLAN is not active.
UPLINK Amber/
Green
On Amber - The port is operating as a 100-Mbps connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
Blinking The NWA/WAC is sending/receiving data through the
port.
Off The port is not connected.
LAN Amber/
Green
On Amber - The port is operating as a 100-Mbps connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
Blinking The LAN port is sending/receiving data through the port.
Off The LAN port is not connected.