ZyXEL Communications WRE2206 - Manually Configuring AP Settings

Chapter 3 Connection Wizard
WRE2206 User’s Guide
17
Figure 5 Wizard: Type a Key
3.2.2 Manually Configuring AP Parameters
If the AP you want to connect to is not listed, then follow these steps to configure the security
settings of the AP manually.
1 Select Setup repeater manually.
2 Type the SSID of the AP into the SSID field.
Figure 6 Wizard: Manually Typing the SSID
3 Configure the security settings. The number of characters accepted by the KEY field is shown in the
following table.