Chapter 7 Wireless
WX Series User’s Guide
101
Setting > Wireless > MAC Authentication. The screen appears as shown.
Figure 48 Network Setting> Wireless > MAC Authentication
The following table describes the labels in this screen.
Table 24 Network Setting > Wireless > MAC Authentication
LABEL DESCRIPTION
General
SSID Select the SSID for which you want to configure MAC filter settings.
MAC Restrict
Mode
Define the filter action for the list of MAC addresses in the MAC Address table.
Select Disable to turn off MAC filtering.
Select Deny to block access to the WX Device. MAC addresses not listed will be allowed to
access the WX Device.
Select Allow to permit access to the WX Device. MAC addresses not listed will be denied access
to the WX Device.
MAC Address List
Add New MAC
Address
This field is available when you select Deny or Allow in the MAC Restrict Mode field.
Click this if you want to add a new MAC address entry to the MAC filter list below.
# This is the index number of the entry.
MAC Address This is the MAC addresses of the wireless devices that are allowed or denied access to the WX
Device.
Modify Click the Edit icon and type the MAC address of the peer device in a valid MAC address format
(six hexadecimal character pairs, for example 12:34:56:78:9a:bc).
Click the Delete icon to delete the entry.
Cancel Click Cancel to restore the default or previously saved settings.
Apply Click Apply to save your changes.
To Next Page
Loading...
