Chapter 7 Wireless
WX Series User’s Guide
102
7.4.1 Add/Edit MAC Addresses
Click Add new MAC address in the Network Setting > Wireless > MAC Authentication screen to add a
new MAC address. You can also click the Edit icon next to a MAC authentication rule to edit the rule.
Enter the MAC addresses of the wireless devices that are allowed or denied access to the WX Device in
these address fields. Enter the MAC addresses in a valid MAC address format, that is, six hexadecimal
character pairs, for example, 12:34:56:78:9a:bc.
Figure 49 Network Setting> Wireless > MAC Authentication > Add/Edit
7.5 WPS Settings
WiFi Protected Setup (WPS) allows you to quickly set up a wireless network with strong security, without
having to configure security settings manually. To set up a WPS connection between two devices, both
devices must support WPS. It is recommended to use the Push Button Configuration (PBC) method if your
wireless client supports it. See Section 7.11.8.3 on page 119 for more information about WPS.
Note: The WX Device applies the security settings of the main SSID (SSID1) profile (see Section
7.2 on page 93).
Note: The WPS switch is grayed out when WiFi is disabled.
Click Network Setting > Wireless > WPS. The following screen displays. Click this switch and makes it turn
blue. Click Apply to activate the WPS function. Then you can configure the WPS settings in this screen.
To Next Page
Loading...
