Chapter 2 Hardware
WX Series User’s Guide
25
2.4 Wall Mounting
Do the following to attach your WX Device to a wall.
2.4.1 The WX3401-B0 Wall-Mounting
You may need screw anchors if mounting on a concrete or brick wall.
Figure 19 The WX3401 Screw Specifications
1 Select a position free of obstructions on a wall strong enough to hold the weight of the device.
2 Mark two holes on the wall at the appropriate distance apart for the screws.
Be careful to avoid damaging pipes or cables located inside the wall
when drilling holes for the screws.
Table 7 The WX3401 Wall Mounting Information
Distance between holes 89.00 mm
M4 Screws Two
Screw anchors (optional) Two
To Next Page
Loading...
