Chapter 18 Diagnostic
WX Series User’s Guide
151
18.3 Ping & TraceRoute
Use this screen use ping, traceroute, or nslookup for troubleshooting. Ping and traceroute are used to
test whether a particular host is reachable. After entering an IP address and clicking on one of the
buttons to start a test, the results will be shown in the Ping/Traceroute Test area. Use nslookup to find the
IP address for a host name and vice versa. Click Maintenance > Diagnostic to open the screen shown
next.
Figure 83 Maintenance > Diagnostic
The following table describes the fields in this screen.
Table 44 Maintenance > Diagnostic
LABEL DESCRIPTION
Address Type the IP address of a computer that you want to perform ping, traceroute, or nslookup in
order to test a connection.
Ping Click this to ping the IPv4 address that you entered.
Ping 6 Click this to ping the IPv6 address that you entered.
Trace Route Click this to display the route path and transmission delays between the WX Device to the IPv4
address that you entered.
Trace Route 6 Click this to display the route path and transmission delays between the WX Device to the IPv6
address that you entered.
Nslookup Click this button to perform a DNS lookup on the IP address of a computer you enter.
To Next Page
Loading...
