Chapter 2 Hardware
WX Series User’s Guide
26
Figure 20 The WX3401 Wall Mounting Distance
3 If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the full
depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way in - leave
a small gap of about 0.5 cm.
If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the screws all
the way in - leave a gap of about 0.5 cm.
4 Make sure the screws are fastened well enough to hold the weight of the WX Device with the
connection cables.
5 Align the holes on the back of the WX Device with the screws on the wall. Hang the WX Device on the
screws.
Figure 21 The WX3401 Wall Mounting Example
2.4.2 The WX3100-T0 Wall-Mounting
You may need screw anchors if mounting on a concrete or brick wall.
To Next Page
Loading...
