Chapter 1 Introduction
WX Series User’s Guide
15
Figure 5 Mesh Application
The following table describes the icons used in the figure.
Note: Your router must have an Internet connection whether it supports MPro Mesh or not.
Note: If your router supports Zyxel MPro Mesh, it will serve as the router controller in a Mesh
network with the WX Device.
Note: If your router does not support Zyxel MPro Mesh, your WX Device will automatically
become the AP controller.
Table 2 Icons used in Mesh Application
ICON DESCRIPTION
C
Router Controller (the DX5301-B0 in Scenario 1, see Section 4.3.1 on page
38) or AP controller (the first WX Device in Scenario 2, see Section 4.3.2 on
page 43)
AP Access Point
RP Repeater
C1 Client1
C2 Client2
APC Access Point coverage area
RPC Repeater coverage area
To Next Page
Loading...
