Chapter 3 The Web Configurator
WX Series User’s Guide
35
Wireless General Use this screen to configure the WiFi settings and wireless LAN
authentication/security settings.
Guest/More
APGuest/More
AP
Use this screen to configure multiple BSSs on the WX Device.
MAC
Authentication
Use this screen to block or allow wireless traffic from wireless devices of
certain SSIDs and MAC addresses to the WX Device.
WPS Use this screen to configure and view your WPS (WiFi Protected Setup)
settings.
WMM Use this screen to enable or disable WiFi MultiMedia (WMM).
Others Use this screen to configure advanced wireless settings.
Channel Status Use this screen to scan WiFi channel noises and view the results.
Operating
Modes
Use this screen to enter the SSID and configure the wireless security
between the WX Device and the wireless network to which you want to
connect.
AP List Use this screen to scan the wireless networks in the WX Device’s area.
Home
Networking
Home
Networking
Use this screen to configure DHCP/Static IP settings, and other advanced
properties.
System Monitor
Log Log Use this screen to view the status of events that occurred to the WX
Device. You can export or e-mail the logs.
Multicast Status IGMP Status Use this screen to view the status of all IGMP settings on the WX Device.
MLD Status Use this screen to view the status of all MLD settings on the WX Device.
WLAN Station
Status
WLAN Station
Status
Use this screen to view the wireless stations that are currently associated
with the WX Device.
Maintenance
System System
Use this screen to set Device name.
User Account User Account Use this screen to change user password on the WX Device.
Remote
Management
Remote
Management
Use this screen to enable specific traffic directions for network services.
Time Time Use this screen to change your WX Device’s time and date.
Firmware
Upgrade
Firmware
Upgrade
Use this screen to upload firmware to your WX Device.
Backup/Restore Backup/Restore Use this screen to backup and restore your WX Device’s configuration
(settings) or reset the factory default settings.
Reboot Reboot Use this screen to reboot the WX Device without turning the power off.
Diagnostic Ping&Traceroute Use this screen to identify problems with the WX Device. You can use
Ping or TraceRoute to help you identify problems.
Table 9 Configuration Menus Summary (continued)
LINK TAB FUNCTION
To Next Page
Loading...
