Chapter 6 Connection Status
WX Series User’s Guide
91
Figure 42 LAN Setup
Each field is described in the following table.
Table 17 Status Screen
LABEL DESCRIPTION
LAN IP Setup
IP Address Enter the LAN IPv4 address you want to assign to your WX Device in dotted decimal
notation, for example, 192.168.1.2 (factory default).
Subnet Mask Type the subnet mask of your network in dotted decimal notation, for example 255.255.255.0
(factory default). Your WX Device automatically computes the subnet mask based on the IP
address you enter, so do not change this field unless you are instructed to do so.
Save Click Save to save your changes.
To Next Page
Loading...
