Chapter 7 Wireless
WX Series User’s Guide
94
Figure 43 Network Setting > Wireless > General
The following table describes the general WiFi labels in this screen.
Table 18 Network Setting > Wireless > General
LABEL DESCRIPTION
Wireless
Wireless Select Keep the same settings for 2.4G and 5G wireless networks and the 2.4 GHz and 5 GHz
wireless networks will use the same SSID and wireless security settings.
Wireless Network Setup
Band This shows the wireless band which this radio profile is using. 2.4GHz is the frequency used by IEEE
802.11b/g/n/ax wireless clients while 5GHz is used by IEEE 802.11a/n/ac/ax wireless clients.
Note: The Operating Modes and AP List screen are only available if you select the 5GHz Band.
Wireless Click this switch to enable or disable WiFi in this field. When the switch turns blue , the
function is enabled. Otherwise, it is not.
Channel Select a channel from the drop-down list box. The options vary depending on the frequency
band and the country you are in.
Use Auto to have the WX Device automatically determine a channel to use.
To Next Page
Loading...
