Chapter 2 How to Set Up Your Network
ZyWALL USG 20-2000 User’s Guide
39
2.6.1 Setting Up the WAN IPv6 Interface
1 In the CONFIGURATION > Network > Interface > Ethernet screen’s IPv6 Configuration
section, double-click the wan1.
2 The Edit Ethernet screen appears. Select Enable Interface and Enable IPv6. Select Enable
Auto-Configuration. Click OK.
Note: Your ISP or uplink router should enable router advertisement.
2.6.2 Setting Up the LAN Interface
1 In the CONFIGURATION > Network > Interface > Ethernet screen, double-click the lan1 in
the IPv6 Configuration section.
2 The Edit Ethernet screen appears. Select Enable Interface and Enable IPv6.
Select Enable Router Advertisement and click Add and configure a network prefix for the LAN1
(2006:1111:1111:1111::/64 in this example). Click OK.
To Next Page
Loading...
