2N IP Uni User Manual

Installation manual 2N® IP Uni
47 / 58
•
•
•
•
•
•
•
Static/Dynamic Address Setting Mode Switching
In case your2N
®
IP Unidevice is equipped with 1 or 2 buttons, you can switch the modes using
one button only.
Connect2N
®
IP Unito the power supply (or, disconnect and reconnect it if already
connected).
Wait for the first sound signal .
Press the quick dial button on the main unit 15 times.
Network parameter reset and DHCP switch are signaled by the sound.
For devices with FW versions 2.33 and lower, wait until the device is automatically
restarted.
After restart, the static IP address mode is switched into the dynamic IP address and
vice versa.
Simultaneously, all theSystem / Networkparameters are reset to default values. This is
useful where it is impossible to connect to the device due to wrong VPN configuration, for
example.
The static IP address mode will be switched into the dynamic IP address mode and vice versa
upon restart.
•
Caution
The 15 times 1 sequence must be entered within 30 seconds after the first sound
signal for security reasons. The inter-digit delay may be 2 s at most.


2N IP Uni Specifications

General

Brand	2N
Model	IP Uni
Category	Intercom System
Language	English