Tone Signalling for Calls from ISDN
Dial tone to PRI1 with empty SETUP – set the dial tone type to be generated
by the PRI gateway.
Ring tone – set the ring tone type to be generated by the PRI gateway.
Generate busy tone to PRI1 – set the busy tone type to be generated by the
PRI gateway into the PRI 1 interface.
Generate busy tone to PRI2 – set the busy tone type to be generated by the
PRI gateway into the PRI 2 interface.
– set the ring tone type to be generated by theRing tone from PRI1 to PRI2
PRI1 interface into the PRI 2 interface.
Numbering Plan Settings
– use these parameters to set the Numbering plan for the calledCDN, CGN
(CDN) and calling (CGN) numbers.
Binary value Decimal value Description
0000 0 Unknown numbering plan
0001 1 ISDN/Telephony numbering plan
0011 3 Sata numbering plan
0100 4 Telex numbering plan
1000 8 National standard numbering plan
1001 9 Private numbering plan
1111 15 Reserved for Extension
ISDN Parameters – Monitoring
PRI1 Alerts
Send SMS at state changes – enable/disable alert sending upon PRI1 state
change.
PRI2 Alerts
Send SMS at state changes – enable/disable alert sending upon PRI2 state
change.
Caution
This service is subject to licence! Refer to forManagement/Licence key
the current GSM gateway licence state details.
To Next Page
Loading...
