PRI Common Settings
– Timeout for ISDN line deactivation detection [s] an SMS alert on
PRI1/PRI2 deactivation is sent after this timeout.
– an SMS alert on PRI1/PRI2Timeout for ISDN line activation detection [s]
activation is sent after this timeout.
Numbers where SMS will be sent to – list of numbers to which the SMS alert
shall be sent.
Text of SMS – SMS alert text with the following parameters:
%P(x|y), where "x" represents any text concerning PRI1 and "y" represents
any text concerning PRI2.
%A(x|y), where "x" represents any text for interface deactivation and "y"
represents any text for interface activation.
Alive SMS Interval Settings
Send Alive SMS – enable/disable sending of ALIVE SMS.
– Alive SMS sending time.Time [hh:mm]
– Alive SMS sending interval.Days interval
Numbers where SMS will be sent to – list of numbers to which the Alive SMS
shall be sent.
– Alive SMS text.Text of SMS
GSM Basic Parameters
GSM Selection
Assignment of GSM channel
Cyclical
Locked – peer to ISDN channel
Smart – least used minutes
Smart – most remaining minutes
Linear – always first free module
Number of Digits Dialled from ISDN
Minimum digits – set the minimum count of digits to be dialled into the GSM
network.
Maximum digits – set the maximum count of digits to be dialled into the GSM
network.
Wait for next digit [s] – set the timeout for to2N StarGate / BlueTower
®
wait for the next digit dialled from ISDN to GSM.
Caution
The selection has a higher priority thanLocked – peer to ISDN channel
the LCR table. All outgoing/incoming calls are locked in the GSM-ISDN
channel pair. The GSM channel is selected cyclically for outgoing VoIP
calls.
The Smart – least used minutes and Smart – most remaining
rules are useful where different limit settings are used for SMS.minutes