Calls
Relax timeout [s] – set the timeout between the end of one and beginning of
the next call via one and the same GSM module (incoming and outgoing calls are
rejected during this timeout). The recommended relax value is 2 seconds –
please do not change this setting unless absolutely necessary.
Timeout for ringing to GSM [s] – set the ringing timeout for outgoing calls to
GSM. If not answered or terminated within this timeout, the call will be
terminated automatically by the gateway when this timeout elapses.
– Source interface for CallBack select the CallBack source interface
for CallBack routing. The LCR table must include the appropriate outgoing traffic
rule: if, for example, a VoIP port is the CallBack source interface, routing
from VoIP to GSM must be defined in the LCR.
Delay for fast CallBack [s] – set the delay between the CallBack request and
outgoing call if Auto end to CallBack request is active.
Holiday List
List of days on which calls will be routed like on weekends in the LCR.
DTMF Settings
Minimum delay between two identical DTMF characters [s/100] received.
Tone Detector Settings
The GSM gateway can automatically detect user defined tones transmitted by
GSM/UMTS for setting up outgoing calls to the GSM/UMTS networks. In general, these
are tones of a transferred number. For the purpose of such detection, the GSM
gateway automatically terminates the call and tries to set it up via another available
outgoing group (if defined in the LCR).
Frequency 1;2;3;4 – define the frequencies for the tone to be detected.
Sequence list – set the sequence of the tones to be detected.
Voice Message Detector Settings
Minimum percent to match – set the match percentage range in which the
voice message is detected as identical with one of the voice messages recorded
section under index 30–37. Thein the Gateway control/Voice messages
recommended value is 70–90%.
Ericsson Module Settings
Transmission volume [dB] – set the module volume for the outgoing direction.
Reception volume [dB] – set the module volume for the incoming direction.
To Next Page
Loading...
