2N stargate - Page 84

842N TELEKOMUNIKACE a.s., www.2n.cz
®
Cinterion Module Settings
Transmission volume [dB] – set the module volume for the outgoing direction.
Reception volume [dB] – set the module volume for the incoming direction.
Enable connection tone – enable the connection tone.
End call with SHUP – end calls with the SHUP command.
Enable HR codec – enable the Half Rate codec for the GSM network.
Enable AMR codec – enable the Adaptive Multi-Rate codec for the GSM
network.
Echo cancelling (MC55) – enable/disable echo cancelling for Cinterion MC-55.
Wavecom Module Settings
GSM-band selection – select the GSM frequencies for the mobile network.
Echo cancelling – enable/disable echo cancelling for the module.
Transmission volume [dB] – set the module volume for the outgoing direction.
Reception volume [dB] – set the module volume for the incoming direction.
Enable HR codec – enable the Half Rate codec for the GSM network.
Enable AMR codec – enable the Adaptive Multi-Rate codec for the GSM
network.
Sierra Wireless Module Settings
Transmission volume [dB] – set the module volume for the outgoing direction.
Reception volume [dB] – set the module volume for the incoming direction.
Type of used networks – select the network types for the module to log in.
Searching priority – set the network type searching priority.
Init module after call – initialise the module settings after call end.
Echo canceller mode – enable/disable echo cancelling for the module.
Enable noise reduction – enable/disable noise reduction for the module.
Telit Module Settings
Type of used networks – select the network types for the module to log in.
Automatic band selection – enable the automatic mobile frequency band
selection.
GSM-band selection – select the GSM frequencies for the mobile network.
UMTS-band selection – select the GUMTS frequencies for the mobile network.
Enable HR codec – enable the Half Rate codec for the GSM network.
Enable AMR codec – enable the Adaptive Multi-Rate codec for the GSM
network.
Enable FR AMR Wideband codec – enable the Full Rate Adaptive Multi-Rate
codec for UMTS.
Enable UMTS AMR Version 2 codec – enable the Full Rate Adaptive Multi-Rate
version 2 codec for UMTS.
Enable UMTS AMR Wideband codec – enable the Adaptive Multi-Rate
WideBand for UMTS.
Enable echo canceller – enable/disable echo cancelling for the module.
Enable noise reduction – enable/disable noise reduction for the module.