124 CHAPTER A: TELEPHONE INSTALLATION AND MAINTENANCE
On my VCX Business
Telephone, I added a
One-Touch speed
dial, but
the telephone does not dial
that number.
Verify that you have correctly set up speed dialing. For
details, see
Speed Dialing.
My telephone keeps
ringing after I pick up the
handset.
■ Your telephone may have lost connection to the
system immediately after a call came in. Remove the
Ethernet cord from the jack, then re-insert it into
the wall jack.
■ Wait a few seconds. If the telephone continues to
ring, disconnect the electrical power for your
telephone, and then plug it back in.
The display panel shows
“Wait for NCP.”
Your telephone may be disconnected from the system.
Hang up your telephone and wait a few seconds. Then
pick up the handset. If the message still appears on
your telephone display panel, contact your
administrator.
Table 11 Possible Problems (continued)
Possible Problem Suggested Solutions
To Next Page
Loading...