3Com 3102 - Using the Hands Free Feature; Using a Headset; Returning to the Headset after a Long Delay

Using the Hands Free Feature 59
For Model 2101 (Basic Phone), you must activate the speaker by pressing
Feature + 104 and then adjust the speaker volume.
Using the Hands
Free Feature
The Hands Free feature answers your phone automatically by turning on
the Speaker when a call arrives.
If your telephone is part of a bridged extension, see Hands Free and
Bridged Line Calls for additional information.
To enable or disable the Hands Free feature, press the HANDS FREE
button on the phone. The red light next to the button comes on
(enabled) or goes out (disabled).
To enable the Hands Free feature (Model 3101SP), press Feature + 100
before calls come in to your telephone. To disable Hands Free Active on
Intercom, press Feature + 100 again.
Using a Headset The Model 3102 Business Telephone has a headset jack located on the
underside of the telephone.
To prepare the headset for all calls on either phone:
1 Plug the headset connector into the headset jack on the underside of the
telephone.
2 Press the Headset button. By default, this button is the Access button
just below the Program button at the top right corner of the telephone.
3 Verify that the indicator light next to the Headset button comes on.
To answer a call when you are using the headset:
1 Put the headset on. When a call comes in, press the System Appearance
button beside the flashing light. You are connected to the call.
The handset can be either on hook or off hook.
2 To end a call when you are using the headset, press the Release button
on the telephone. By default, the Release button is located at the
bottom of the right column of Access buttons.
Returning to the
Headset After a
Long
Delay
Certain brands of headsets enter a power-saving mode that prevents the
telephone from ringing for one or more calls when both of these
conditions are true: