Using RF Measurements from MAPs 171
5 Click Next.
The import progress is displayed. When the import is done, check the
Total valid RF measurements found line in the progress messages.
If the number is greater than 0, 3WXM successfully imported
measurements.
If the number is 0, no measurements were imported. Try the import
again. If you are using a site survey file, verify that the map name is
correct.
After you apply the network RF measurements, you correct the
attenuation factors for the floor. Go to “Optimizing the RF Coverage
Model” on page 179 for information about this topic.
To Next Page
Loading...
