3Com 3CRWX120695A - Using RF Measurements from MAPs

170 CHAPTER 8: OPTIMIZING A NETWORK PLAN
The following sections describe how to import RF measurements from
your network, or how to import RF measurements from an Ekahau site
survey.
Using RF
Measurements
from MAPs
You can apply the RF measurements derived from the MAPs in your
WLAN (which regularly monitors the RF environment) to your network
plan. The RF measurements are taken from MAP radios.
After you apply the RF measurements, the floor’s RF model (obstacles)
will be optimized with this data.
To import RF measurements:
1 Access the Building wizard, if not already open.
2 Click Optimize RF Coverage at the top of the wizard. The Optimize RF
Coverage page appears.
3 Click Import Measurements. The Import RF Measurements wizard
appears.
4 Select Network as the source of the measurements.