78 CHAPTER 3: CONFIGURING WIRELESS SERVICES
Task Ta ble Table 12 contains the tasks you need to perform to create VoWIP access
services. For a summary of configurable items, see “Step Summary” on
page 81.
Table 12 Creating a Service for VoWIP Access
Task Path Primary Parameters to Configure
“Step Summary”
on page 56
Expand the WX switch icon in the
Organizer panel; right-click Service
Profiles > Insert > Service Profile
1 From Service Profile tab:
SSID name: enter name
SSID type: select Encrypted
Beacon: not selected (hide presence of SSID for
marginally improved security)
Fall Through Auth: None
2 From Encryption tab:
Security mode: select WEP or WPA/PSK (provides higher
level of security)
3 If you select WEP:
802.1X Auth Enabled: select yes
TKIP enabled: select no
Click Finish
4 If you select WPA/PSK (Must be supported by your
VoWIP device):
802.1X Auth Enabled: select no
PSK Auth: select enabled
Pre-shared Key: (64 Hex characters) or enter a pass
phrase and click Generate Key
TKIP enabled: select yes
Click Finish
“Create a Radio
Profile” on
page 59
Expand the WX switch icon in the
Organizer panel; right-click Radio
Profiles > Insert > Radio Profile
1 From Radio Profile tab:
Radio profile name: enter a name
2 From Service Profile tab:
Select the VoWIP service profile in the Available Service
Profiles list.
Click Add; then click Finish
To Next Page
Loading...
