3Com 3CRWX120695A - Page 80

80 CHAPTER 3: CONFIGURING WIRELESS SERVICES
“Specify
Network Access
Rules” on
page 64
Expand the AAA icon in the
Organizer panel; right-click Network
Access Rules > Insert > MAC
Network Access
1 From MAC Network Access page:
 Matching user Glob: enter **
 SSID: enter SSID name
2 From Authentication tab:
 Select Choose Available > RADIUS or Local
 Click Finish; then click Finish again
“Set Up VLANs
on WX
Switches” on
page 66
Expand the WX switch icon in the
Organizer panel, right-click VLANs
> Insert > VLAN
Note: 3Com recommends
completely isolating the VoWIP VLAN
as a best practice procedure in your
WLAN.
Setup VoWIP VLAN.
1 From VLAN Setup tab:
 VLAN ID: select number (must be unique)
 VLAN Name: enter name (must be unique)
 IP Address: enter IP Address
2 From VLAN Member Selection tab:
 VLAN Name: enter VLAN name for the VoWIP phones
 Available Members: select port(s) to reach other ports
on the VoWIP VLAN or the VoWIP gateway/PBX; click
Add
3 From Spanning Tree tab:
 Select STP options
4 From Spanning Tree Port Setup tab:
 Select STP port options
5 From VLAN IGMP tab:
 Uncheck Enabled
 Click Finish
“Configure
Access Control
Lists” on
page 84
Expand the WX switch icon in the
Organizer panel, right-click on ACLs
> Insert
1 From ACL Setup tab:
 Click New; select an ACE
 Enter ACE set up information
 Click Finish
2 From ACL Map tab:
 Map ACL to VoWIP VLAN
 Click Finish
Table 12 Creating a Service for VoWIP Access (continued)
Task Path Primary Parameters to Configure