3Com 4200G PWR - Setting Up Overview

34 CHAPTER 3: SETTING UP FOR MANAGEMENT
Figure 10 SNMP Management over the Network
Refer to “Setting Up SNMP Management V1 or V2” on page 50.
Setting Up
Overview
This section gives an overview of what you need to do to get your Switch
set up and ready for management when it is in its default state. The
whole setup process is summarized in Figure 11. Detailed procedural
steps are contained in the sections that follow. In brief, you need to:
■ Configure IP information manually for your Switch or view the
automatically configured IP information
■ Prepare for your chosen method of management
SNMP Network Management
Workstation
Switch
Connect over Network
using SNMP
10014914AA.book Page 34 Friday, July 7, 2006 2:08 PM