62 CHAPTER 5: UPGRADING SOFTWARE
Table 11 Switch 4200G Filenames
2 To download the Web user interface file, enter:
[4200G] tftp aaa.aaa.aaa.aaa get http.web
3 To download the default configuration file, enter:
[4200G] tftp aaa.aaa.aaa.aaa get 3ComOScfg.def
4 To download the bootrom file, enter:
[4200G] tftp aaa.aaa.aaa.aaa get s3u01_00.btm
The bootrom firmware may not require upgrading for every software
upgrade, therefore there may not be a new bootrom (.btm) file to
download.
Command Line Interface Switch Setup
1 To set the Switch to boot from the new software you have downloaded,
enter the following:
[4200G] boot boot-loader
unit1>flash:/s3t03_01_00s56.app
2 To set the Switch to load the new bootrom firmware, enter:
[4200G] boot bootrom unit1>flash:/s3u01_00.btm
The following prompt is displayed:
This will update Bootrom on unit 1. Continue? [Y/N]
Type Y to update the bootrom.
3 To set the Switch to load the new web management file, enter:
[4200G] boot web-package s3v01_00.web main
4 You will now need to reboot the Switch. The Switch will upgrade the
bootrom firmware and boot from the specified software .app file.
Filename Prefix/Suffix Switch
s3t / .app Switch 4200G software
s3u / .btm Switch 4200G bootrom software
s3v / .web Switch 4200G web management software
10014914AA.book Page 62 Friday, July 7, 2006 2:08 PM
To Next Page
Loading...
