Package Contents 11
(7) Self-adhesive Pads
The unit is supplied with four self-adhesive rubber pads.
Do not apply the pads if you intend to rack mount the
unit.
If the unit is to be part of a free-standing stack, apply
the pads to each marked corner area on the underside
of the unit. Place the unit on top of the lower unit,
ensuring that the pads locate with the recesses of the
lower unit.
Rear Panel
The rear panel of the Switch contains a power supply
socket and a recovery button.
(8) Power Socket
The Switch automatically adjusts to the supply voltage.
Only use the power cord that is supplied with the unit.
(9) Recovery Button
The recovery button reinitializes the Switch. This returns
the Switch to the factory default settings if, for
example, you have forgotten the default IP address, or
forgotten your user name or password.
CAUTION: 3Com recommends that you back up your
configuration settings before you recover the Switch,
otherwise your configuration may be lost. Refer to
“Configuration” on page 41 for details.
Package Contents
Before installing and using the Switch, verify that your
Switch package is complete. The Switch comes with:
■ One power cord
■ Four standard height, self-adhesive rubber pads
■ One mounting kit
■ Installation CD
■ This User Guide
■ Warranty flyer
The Switch is powered from the AC supply.
If any of the above items are damaged or missing,
contact your 3Com network supplier immediately.
To Next Page
Loading...
