3Com Baseline 2848-SFP Plus - Modifying Trunk Settings; Deleting a Trunk

38 CONFIGURING THE SWITCH
The Status column refers to the speed and duplex mode
of the trunk members. To change the speed and duplex
mode of the trunk, click the Modify/Delete tab.
Figure 16 Trunking Membership Screen
Modifying Trunk Settings and Deleting a Trunk
Use the Modify/Delete tab to modify the trunk name
and configure flow control and duplex settings of the
trunk.
To modify trunk settings:
1 On the Modify/Delete tab, modify any of the following
settings:
■ Name — Allows you to label an interface (up to
characters)
■ Flow Control — Allows automatic or manual
selection of flow control.
■ Speed Duplex – Allows auto-negotiation to be
enabled or disabled. When autonegotiation is
disabled, you can force the settings for speed,
duplex mode, and flow control.
2 Click Apply.
To delete a trunk, click the corresponding Delete check
box, and then click Apply.
Figure 17 Trunking Screen
Viewing the Trunk Summary
If you want to view a summary of the trunk settings,
click the Summary tab.