Need help?Do you have a question about the 3Com Baseline 2816 and is the answer not in the manual?
General| Ports | 16 |
|---|---|
| Layer | Layer 2 |
| Switching Capacity | 3.2 Gbps |
| MAC Address Table | 8K |
| Power Supply | Internal |
| Manageable | No |
| Model | 3Com Baseline Switch 2816 |
| Type | Switch |
| Dimensions | 440 x 180 x 44 mm |
| Jumbo Frame Support | No |
Instructions on how to connect and supply power to the switch.
Steps to connect network devices to the switch using cables.
Step-by-step guide to insert an SFP transceiver into the switch.
Step-by-step guide to remove an SFP transceiver from the switch.
Instructions for using the Discovery application to find and connect to the switch.
How to access the web interface directly if the IP address is known.
Steps to set or change the administrator password for security.
How to configure the switch's IP address settings.
Step-by-step guide to manually set the IP address for the switch.
How to configure port speed, duplex, and flow control.
Steps to restore the switch to its original factory settings.
How to install new firmware releases for the switch.
Steps to recover access if the admin password is lost.
How to recover access if the static IP address is forgotten.
Crucial safety precautions to read before installing the switch.
To Next Page