40 CHAPTER 3: SETTING UP FOR MANAGEMENT
Figure 14 Web interface management over the network
Refer to “Setting Up Web Interface Management” on page 42.
SNMP Management You can manage a Switch using any network management workstation
running the Simple Network Management Protocol (SNMP) as shown in
Figure 15. For example, you can use the 3Com Network Supervisor
software that is provided on the CD-ROM that accompanies your Switch.
Figure 15 SNMP management over the network
Refer to “Setting Up SNMP Management” on page 43.
Setting Up
Command Line
Interface
Management
This section describes how you can set up command line interface
management using a local console port connection or over the network.
CLI Management via
the Console Port
To manage a Switch using the command line interface via the local
console port connection:
1 Ensure you have connected your workstation to the console port correctly
as described in “Connecting to the Console Port” on page 33.
2 Your Switch is now ready to continue being managed and/or configured
through the CLI via its console port.
DUA1750-0AAA01.book Page 40 Friday, December 5, 2003 10:24 AM