3Com Switch 4210 Series User Manual

38 CHAPTER 3: SETTING UP FOR MANAGEMENT
Figure 34 User View Login
3 Enter the system-view command and press Return.
To confirm that you are in the System View, the following should be displayed:
[4210]
Enter interface vlan 1 and Enter.
4 Enter the IP address and subnet mask for the switch as follows:
ip address xxx.xxx.xxx.xxx mmm.mmm.mmm.mmm
and Enter.
(where xxx.xxx.xxx.xxx is the IP address and mmm.mmm.mmm.mmm is the subnet
mask of the switch)
5 Select the quit command and enter the default gateway for the switch:
ip route-static 0.0.0.0 0.0.0.0 xxx.xxx.xxx.xxx
(where xxx.xxx.xxx.xxx is the IP address of the default gateway)
6 From the User View, enter the save command to save the configuration to your
switch as the configuration is not saved automatically when the switch is powered
down.
The initial set up of your switch is now complete and the switch is ready for you to
set up your chosen management method. See “Methods of Managing a Switch”
on page 29.
If you do not intend to use the command line interface using the console port to
manage the switch, you can disconnect the serial cable and close the terminal
emulator software.

3Com Switch 4210 Series Specifications

General

Model	3Com Switch 4210 Series
Layer	Layer 2
Management	CLI
VLAN Support	Yes
QoS	Yes
Jumbo Frame Support	Yes
Power Supply	Internal
Operating Temperature	0°C to 40°C
Relative Humidity	10% to 90% non-condensing
Uplink Ports	4 SFP ports (on 24-port model), 4 SFP ports (on 48-port model)
Dimensions (W x D x H)	440 x 260 x 44 mm (24-port model), 440 x 260 x 44 mm (48-port model)