Cut off 2”/5 cm of print material from the end. Select the checkmark to continue.14.
NOTE: Ensure the material is not bent or creased. If the material is not
straight, pull out the damaged material from the cartridge. Cut off and
dispose the portion that is not straight.
Insert the print material under the cartridge clamp roller of cartridge bay 1 and into15.
the material tube. Select the checkmark to continue.
Continue to manually feed the print material through the material tube until it begins16.
to extrude from print jet 1 into the jet wiper assembly. Select the checkmark to
continue.
NOTE: When the material reaches far enough into the extruder, the extruder
motor will assist with feeding the material further into the print jet.
To Next Page
Loading...
