Need help?Do you have a question about the 3D Systems CubeX Duo and is the answer not in the manual?
General| Number of Print Heads/Extruders | 2 |
|---|---|
| Nozzle Diameter | 0.4 mm |
| Filament Diameter | 1.75 mm |
| Operating System Compatibility | Windows, Mac |
| Build Volume | 275 x 265 x 240 mm |
| Layer Resolution | 70 microns |
| Materials | ABS, PLA |
| Connectivity | USB |
| Power Requirements | 110-240 V |
| Print Technology | Fused Filament Fabrication (FFF) |
Explains safety symbols and their meanings used in the manual.
General safety rules and precautions for operating the CubeX 3D printer.
Steps to connect power, turn on the printer, and reach the activation screen.
Instructions for activating the CubeX printer using its serial number and ID to unlock it.
How to verify the alignment of the X, Y, and Z axes after shipping.
Using the LEVEL menu to check print jet tip alignment with the print pad.
Steps to adjust the Z-GAP to set the correct distance between print jet and print pad.
Step-by-step guide to installing a new material cartridge into the printer.
Steps for threading filament and inserting the material cartridge into its bay.
Pushing filament to the print jet and checking initial material output.
Ensuring proper setup, applying glue, and understanding critical warnings before printing.
Instructions for inserting the USB stick and selecting the .CUBEX file to print.
How to select the 'Print' option from the main menu to start the print job.
Step-by-step guide for installing the Cubify Invent software and entering the license key.
Instructions for downloading the CubeX software and running the setup executable.
Following the installer wizard, selecting destination, and beginning installation.
Important warnings about hot print jet tips and material changes during printing.
Tool to select which print jets print which parts for multi-material printing.
Safety precautions for the ultrasonic tank and overview of hot water/caustic soda methods.
Essential safety precautions and personal protective equipment for handling caustic soda.
Procedure for unblocking the print jet tip using a drill bit, with safety warnings.
Steps to unblock the print jet using a paper clip, with safety warnings.
Finalizing the Z gap setting by observing and adjusting print pad height.
Adjusting the Y and X offsets for Print Jet 2 based on calibration print lines.
Adjusting the Y and X offsets for Print Jet 3 based on calibration print lines.
Touching relative offset to activate plus and minus adjustment buttons on screen.
Detailed steps for adjusting the offsets for Print Jets 2 and 3.
To Next Page