EasyManuals Logo

3D Systems CubeX Duo User Manual

3D Systems CubeX Duo
37 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #35 background imageLoading...
Page #35 background image
Fig. 121
15. Plug the USB stick into the CubeX 3D Printer and press the control button; you will receive
a notication of your settings being restored. (Fig. 121)
Fig. 122
Fig. 123
16. Your rmware has now been upgraded. (Fig. 122)
RESTORING THE SETTINGS YOUR CUBEX PRINTER FIRMWARE FROM V1.01
Before following these instructions, please follow instruction 1-9 in the section UPGRADING YOUR CUBEX PRINTER
FIRMWARE.
1. Turn on the CubeX 3D Printer. You will see the activation screen.
2. Re-activate your printer using your activation code. (if you do not have your activation code, you can locate it be going
to Cubify.com > MY ACCOUNT > MY DEVICES and then viewing your registered CubeX).
3. Once it is re-activated turn off the CubeX 3D Printer.
4. Plug the USB stick into the CubeX 3D Printer and turn it on, touch the screen and you will receive a notication of your
settings being restored.
5. Your rmware has now been upgraded.
HOW TO CONTACT CUBIFY SUPPORT
If you have any problems with your CubeX that cannot be solved using this manual, please contact
cubifysupport@cubify.com for your support related issues.
SETTING THE CUBEX PRINT JET OFFSETS
CAUTION: Do not use the offset menu unless you have
been advised to do so by Cubify Support, as changes to
this may affect the quality of multi-material prints.
!
34

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the 3D Systems CubeX Duo and is the answer not in the manual?

3D Systems CubeX Duo Specifications

General IconGeneral
Brand3D Systems
ModelCubeX Duo
Category3D Printers
LanguageEnglish

Related product manuals