3D Systems CubeX Duo - Unpacking Your Cubex; Remove Top Lid and Foam; Remove Printer and Accessories; Cut Securing Straps and Ties

8
UNPACKING YOUR CUBEX
1. Open the box and remove the top acrylic lid located between two layers of foam. Set
aside the two foam inserts for future packing. (Fig. 1)
Fig. 1
Fig. 5
Fig. 2
Fig. 6
Fig. 3
Fig. 4
2. With two people, remove CubeX from the box, lift from the metal frame on both sides
of the printer. Place CubeX on a table. (Fig. 2)
3. Remove the material cartridges and tool kit from the bottom of box. (Fig. 3)
4. Using the snips located in the tool kit, cut blue straps away from cardboard. Cut away
all blue zip ties securing the printer carriage. (Fig. 4)
5. Using the snips, cut away all yellow zip ties securing the foam parts in place.
Remove foam packing material. (Fig. 5)
6. Remove all foam ttings. (Fig. 6)