installed cartridges.
Print Plate Calibration
MOVE JETS allows the user to manually move the print jets in the X and Y directions.
LEVEL PLATE is a utility that assists in leveling the print pad to the print jets.
Print Jet Calibration
CONTROL JETS allows the user to test the operation of the extruders and print jets.
OFFSET JETS is a utility that defines the parameters of the space between the print jets.
CAUTION: Do not change any of the values in the OFFSET JETS utility unless
advised to do so by Cubify Support. Any changes will alter the print quality of
your creations.
Network
The Network menu allows the user to connect to a wireless network or to an ad hoc device.
To Next Page
Loading...
