Once the temperature has reached 275°C, select the speed value. Use the up or down4.
arrows to set the speed value to 3.5 RPM.
NOTE: Pressing the speed value twice will place the value at 4.0 RPM. Press
the up or down arrows to increase or decrease the extrusion speed.
Allow the print jet to purge for 10 minutes.5.
NOTE: Purging will clean all previous print material out of the nozzle for
better print quality.
NOTE: The amount of purged material will amount to a small bundle of
material strings.
Once you have finished, reduce the target speed to 0.0 RPM and the target6.
temperature to 0.0°C.
NOTE: Pressing the values twice for target temperature and speed should
change the values to 0.0.
To Next Page
Loading...
