Combination Supports
Introduction
When printing nylon parts while using INF support material, the CubePro software provides
an option to automatically add nylon supports to the INF supports. This reduces warpage
when printing parts with large overhangs and is also effective when printing thin parts. This
auto-combination support creates nylon anchors to prevent warping while providing
support for down-facing surfaces using INF support material.
Warping of curved and angled parts can also be prevented by using both manual
supports and INF supports together.
Combination supports anchor parts very well while still providing good bottom
surfaces.
These supports are not recommended for moving part assemblies.
Procedure
To use the combination of automatic nylon support with INF supports, select Settings1.
> Build Settings.
To Next Page
Loading...
