Nylon Manual Supports
When printing with nylon, parts with large, flat overhanging features may warp. CubePro
software provides readily-accessible nylon supports for your nylon-printed parts.
NOTE: The use of nylon manual supports requires INF support material to
also be installed in the printer and used as a support material type when
setting the build settings. INF support material should be used in addition to
the nylon supports you will add to the part.
After loading your part to the print pad, select Open Manual Support.1.
Select the supports you will need by their height value.2.
NOTE: The height is noted by the variables after the last X in the file name.
You may have have to keep trying different support sizes until you find the
one that contacts the bottom surface of the part needing support. It is okay
for the support to be taller than the bottom surface but it should not extrude
above the part.
NOTE: It is okay for the support to be taller than the bottom surface but the
support should not extrude above the part.
To Next Page
Loading...
