3D Systems Sense User Manual

SENSE SCANNER SETUP
Unpack and set up your scanner and scanner software before you get started with the basics of scanning.
WHAT'S INCLUDED
Included in the box is the Sense 3D scanner with attached USB cable and the Quick Start Guide.
Remove the scanner from the box and plug the USB cable into your computer.
DOWNLOAD THE SENSE SOFTWARE
1. Navigate to Cubify.com.
2. Click Cubes+ > Sense.
3. Click Tech Specs.
4. Click Download Software for your operating system.
INSTALL THE SENSE SOFTWARE
Follow the instructions to complete the software download and installation.
After the software is installed, you link the scanner to a Cubify account.
RUN THE SENSE SOFTWARE
When you installed the Sense software, a shortcut was created on your desktop. Use the shortcut to open the application.
Note: If the scanner is not connected to your computer, a message will state "Device not connected." Plug the USB con-
nector for the scanner into the USB port on your computer.
You will then be prompted to activate your Sense 3D scanner.
3D Systems, Inc. 6

3D Systems Sense Specifications

General

Color scanning	Yes
Duplex scanning	-
Input color depth	16 bit
Maximum scan size	3000 x 3000 mm
Optical scanning resolution	- DPI
Product color	Black
Daily duty cycle (max)	- pages
USB version	3.2 Gen 1 (3.1 Gen 1)
Standard interfaces	USB 2.0, USB 3.2 Gen 1 (3.1 Gen 1)
Power supply type	USB
Power consumption (typical)	2.25 W
Minimum RAM	2048 MB
Minimum processor	Intel® Core™ i5
Minimum storage drive space	4096 MB
Operating temperature (T-T)	10 - 40 °C

Weight and Dimensions

Depth	129 mm
Width	33 mm
Height	178 mm