3D Systems, Inc.
10
30-0433 Rev. A
2. Connect the supplied USB cable to both the device and the host computer.
Touch USB Connection Setup TouchX USB Connection Setup
3. Plug the power cord into an available outlet (for 110V the outlet must be rated for at least 2 Amps, for 220V: 1 Amp).
Next, plug the power connector into the connector (Power) on the back of haptic device. Hook up the Power Supply
(use only the supplied power supply with the haptic device). Plug the power cord into the power supply. The blue
inkwell LED should quickly blink twice to indicate proper performance.
Touch Power Cord Connection TouchX Power Cord Connection
To Next Page
Loading...
Need help?
General