3D Systems, Inc.
6
30-0433 Rev. A
Calibrating the device (Touch): The haptic device may need to be re-calibrated from time to time, particularly if it
has lost power. To calibrate the device, place the stylus in the inkwell and start your haptically enabled application.
The indicator light in the inkwell of the haptic device will be lit a steady blue when the device is properly calibrated.
Alternatively, you can use the Touch Diagnostic Utility (Start>All Programs>3D Systems>Touch Device Drivers).
Touch Calibration
NOTE: For additional calibration instructions, please refer to the RUN 3D SYSTEMS TOUCH SMART SETUP section
Storing the stylus: After the device is calibrated, the stylus may be eft resting on the desk or kept in the inkwell
(Touch only). Keep in mind that storing the stylus in the inkwell increases the risk that the device will be knocked over
or that the stylus will be damaged.
Touch Touch X
Protecting the device from damage: It is best to place the unit rmly on the desktop and away from edges to
reduce the risk of damage to the device from a direct, unintentional elbow hit. The stylus is particularly vulnerable to
sustaining damage when it is in the inkwell.
To reduce the risk of damage, keep the device out of harms way. Pay extra attention if the stylus is stored in the inkwell.
Reassembling the detachable stylus: The Touch stylus is detachable by design. Reassemble it by aligning the blade
on the shaft with the slot in the stylus and inserting it till it snaps in place as shown in the image below.
Align the blade and shaft to reassemble the Touch stylus.
To Next Page
Loading...
Need help?
General